[ Pobierz całość w formacie PDF ]
.SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV.00www.cobra.itXMAKEOPELMOD.VECTRA *YEAR.02 → PETROLDIESEL* Models with original equipment keyless entry system.ALARM/SIRENPosition the compact alarms and the sirens on the driver’s side battery bracket.POSITIONPass the cables using the pre-arrangement in the driver’s side windshield wiper.CENTRAL UNIT POSITIONPosition the modular systems and the modules under the dashboard, driver’s side.POWER SUPPLY+30: connect to a positive general supply wiring of the fuse box.- 31: connect to a ground terminal, under, on the left of the dashboard, driver’s side.IGNITION WIRE+15/54: connect to the BLACK wire, at the position nr.11, in the grey connector, in the fuse box under the driver’s side dashboard.DIRECTION INDICATORSConnect to the BLACK/WHITE wire at the position nr.3 (ant.left), BLACK/WHITE at the position nr.4 (lat.left), BLACK/GREEN at the position nr.9 (lat.right) located in the 50 way black connector, in the central near the battery, in the engine compartment; to the BLACK/GREEN wire at the position nr.9 (post.right) and to the BLACK/WHITE wire at the position nr.8 (post.left) in the 33 way blue connector, in the central placed in the driver’s side boot.ELECTRIC WINDOWSNegative control signalThe closing is obtained timing the RED/YELLOW wire, at the position nr.25, in the 46 way black connector, on the central in the driver’s side door.ACTIVAT./DEACTIVATIONConnections antitheft/vehicleCONTROLSArt.3800 Vehicle Position YELLOW/BLACK BLACK/YELLOW Pos.17, in the 46 way black connector GREY/BLACK BLACK/RED Pos.15, in the 46 way black connector VIOLET RED/YELLOW Pos.25, in the 46 way black connector VIOLET/WHITE ground car body ORANGE positive supply in the fuse box ORANGE/WHITE positive supply in the fuse box The 46 way black connector is located on the way out of the central placed inside the driver’s side door.IMMOBILISATION POINTFuel pumpCut the RED/BLUE wire, at the position nr.3, in the 33 way black connector - C1section - located in the central inside the driver’s side boot.STARTER+50: Cut the BLACK/RED wire located in the wiring harness coming out of the central placed near the battery, in the engine compartment.BONNET SWITCHInstall an additional switch on the headlamp support plate, driver’s side.DOORS SWITCHConnect to the BROWN wire, at the position nr.60, in the connector placed behind the lateral bulkhead, on the left of the friction pedal.BOOT SWITCHConnect to the BLACK wire, at the position nr.6, in the 33 way grey connector - A1section - in the central placed in the driver’s side boot.Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed opvec02gbbt.docas per the instructions given on the product installation manual
[ Pobierz całość w formacie PDF ]